Big Bear Gauntlets 🐻 - how I made claws
I made 2 different sized claws out of wire and paper. I wrap and scrunch the around wire then mold the paper till I was happy with the shape.
I wrapped the paper claws in glad wrap and covered them in tape. (Duct tape would be best, but you girl was fresh out). .
Next I drew a line down the inside and the outside of the claws. My claws were small for big ones you might need to break the claw up into to more sections. I then cut the glad wrap off the paper. I flattened them out and traced them onto paper then out the pattern.
I copied the patterns on to 3mm foam and cut that out. I used a heat gun to curve the foam inwards and point it in different directions so the claws didn't looks so even. .
I glued them together using shoe glue and filled the tip with hot glue to make them a little more solid. .
I wrapped a semi circle of foam around the bottom to make them look like claws when I attached them to the gauntlets. .
Hope this was helpful for anyone. Shoot me a message if you have any questions. I'm so bad at explaining things sometimes... 🐙
#cosplaytutorial #cosplayprop #foamsmithing #cosplaybeginer #cosplay
Still need to fade that teal out more but did get some more painting done and continuing on more after my break posting this, haha. .
Next Dekaron armor set is coming along nicely and trying to get as much as possible done while I have days off from haunting. .
Lots to do before mid November! I hope to have an exciteing announcement or two for you guys soon :)
Checking armor mockup, because Shepard needs special treatment.
Left side is pieces attached together flat by seams,
Right side has a bevel cut on boob cup sides, therefore a more accurate fitting. Gonna use this one for the armor.
Shepard'ın göğüs zırhı için birkaç deneme yapmam lazımdı.
Soldaki direk parçaların birbirine yapıştırılmış hali, sağdaki de açılı kesilerek yapıştırılmış hali. Şekli daha aslında uygun olduğu için sağdakini kullancam.
Deneme yapmak işte bazen bu yüzden gerçekten gerekli. .
#cosplaywip #armor #foamsmithing #evafoam #N7 #commandershepard #valendracosplay
Look at me! I’m not dead! Sorry for the lack of updates guys. With two jobs and school, I hadn’t had much time for the prop shop. So many of you have been asking about the female Odogaron armor so here’s proving that I AM working on it. Need to add some smaller details and it’ll be ready to pattern! Debating on whether I should scale it down a bit. Thoughts? #odogaron #odogaronarmor #odogaroncosplay #foamsmithing #monsterhuntercosplay #chiblingprops
I unfortunately ran out of silver today but I started the paint job on some of my Dekaron aloken armor set. .
First time I’ve done a blue set in a while and I missed the pretty hues, haha. .
Also adding some white detailing to make some of the empty space more interesting. Do you like the white that isn’t highlight? Let me know!
Yes, I have been stingy with the Halloween costume progress and I think it just has been that it has taken me this long to be happy with the outcome. So here's the helmet almost ready for camo painting, the shoulder armor ready and chest plate needing first coat of primer. #colonialmarines #aliens #foamsmithing